Installation; Connection Example - Odin CL-4 Connect Manual

ODIN CL-4 Connect

Installation

Remove all packing materials from the ODIN CL-4 Connect. Check if all foam and plastic padding is
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.

Connection Example

Make your initial connections with all the equipment powered off and ensure that all the main volume
controls are turned completely to the minimum. Follow the steps below. See fig. 04 for more information.
01) Connect one end of the XLR cable to your audio mixer (to MAIN OUT MONO) and the other end of
the cable to the audio signal input on your first speaker.
02) Using an XLR cable, connect the audio signal link on your first speaker to the audio signal input on
your second speaker. Repeat this step to connect multiple speakers.
03) Using a PowerCON power cord, connect the first speaker's power input to the power supply.
04) Using PowerCON power cords, connect the first active speaker's power link to the second speaker's
power input. Repeat this step to connect the third and fourth speaker. Please note that it is allowed
to connect only up to 4 ODIN speakers per phase (16A).
05) In order to enable data signal reception, connect the CL-4 Connect to the first speaker's RJ45 data
input, using a UTP/CAT-5 cable. Connect the first speaker's data link to the second speaker's data
input. Repeat this step to connect multiple speakers. Please note, that to ensure proper data
reception it is allowed to connect a maximum of 12 ODIN speakers.
06) Use the PFL function to get the proper input level for the mixer and adjust the main mix level.
07) After using your equipment, turn off your active speaker cabinets first, then the mixer.
Ordercode: D3915
8
Fig. 04