Network Configuration; Wps Pbc Network Configuration; No Network Configuration - LENCO DIR-100 User Manual

4. Network configuration

1. Normal network configration
Select "Yes" for the normal Wireless Network Configuration: The select the required AP by turning
"Navigate" and confirm it by pressing "Navigate/OK".
Enter WEP or WPA code to connect the WiFi network by select the correct character turning the
"Navigate/OK" button.
Press button to select the next character.
In this condition, press button you can turn left and delete the left chracters at the same time:
When the password is complete please press "Navigate/OK" button to confirm.
Note: Below characters are available for the radio:
Numbers (from 0-9)
English letters (from A to Z and from a to z)
Other charcters (DEL, @, Blank, ! , " , # , $, %, &, * , ' , + and (,)

2. WPS PBC network configuration

Select "Yes WPS" when you would like set up with Wireless Network (WPS PBC) feature: If you are
using a router with WPS button, you may set up the network connection simple via WPS function.
Enter it and go to press the WPS button on your router within 120 seconds.
The connection between the router and the Radio will then be configured automatically.
Select "No" when you do not want to install the network at the moment.

3. No network configuration

Pls select "NO" when you do not like to congigure the network connection at the moment.
Press "Standby" for standby.When the actual date and time is shown the network is configuration is
well done. Date and time, as well as alarms-if activated-will still are shown on the display when in
standby mode.
8