Winding The Lower Thread - Brother BAS-326H-484 Basic Operation Manual

Programmable electronic pattern sewer
Hide thumbs Also See for BAS-326H-484:
Table of Contents

Advertisement

4. PREPARATION BEFORE SEWING

4-3. Winding the lower thread

Do not touch any of the moving parts or press any objects against the machine while winding the lower thread, as this may
result in personal injury or damage to the machine.
3443B
26
CAUTION
1. Place the bobbin onto the bobbin winder shaft (1).
2. Thread the thread as shown in the illustration, wind the
thread around the bobbin several times, and then press the
bobbin presser arm (2).
3. Turn on the power.
4. Lower the work clamps (and the intermittent presser foot)
before depressing the start switch.
Home position detection will be carried out.
5. Touch the Wind key (4) on the screen.
6. The display will switch to the thread winding mode screen.
7. Check that the needle does not touch the work clamps (and
the intermittent presser foot), and then lower the work
clamps (and the intermittent presser foot) before depressing
the start switch.
8. Keep depressing the start switch until the lower thread stops
being wound onto the bobbin.
9. Once winding of the set amount of lower thread (80 - 90% of
the bobbin capacity) is completed, the bobbin presser arm
(2) will return automatically.
10. Remove the bobbin, hook the thread onto the knife (3), and
then pull the bobbin in the direction of the arrow to cut the
thread.
11. Touch the OK key (5) to return to the previous screen.
3550B
(4)
(5)
BAS-326H-484, BAS-326H-484 SF

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents