Lan Configuration; Wan Configuration - C-Data FD612H User Manual

2.3 LAN Configuration

1. In the navigation tree on the left, choose Advanced Setup> LAN Port Work Mode. In the
pane onthe right, determine whether the LAN port works mode.
1) RG: LAN port works in layer 3 mode, that is, the gateway mode;
2) ONT: LAN port works in layer 2mode, that is, the bridge mode;
Note: As the LAN Port configure to ONT mode, the port can't visit the ONT WEB interface
after you connect the ONT with OLT.

2.4 WAN Configuration

WAN in route mode: The ONT functions as a gateway. The IP address of the ONT can
be obtained through DHCP, Static, or PPPoE. The IP address of the PC connected to the
ONT can be obtained from the DHCP address pool of the ONT or can be set manually.
WAN in bridge mode: The ONT functions as a relay and does not process data. The
ONT does not obtain the IP address allocated by the upper-layer device and it does not
allow manual configuration of a static IP address. The IP address of the device connected
to the ONT can be obtained through DHCP, PPPoE, or static.
9