Plc Side Setting (Cp-9200Sh Series, Cp-312, Cp-317 Series) - Mitsubishi Electric GOT1000 Series Connection Manual

6.3.4 PLC side setting (CP-9200SH
series, CP-312, CP-317
series)
POINT POINT POINT
YASKAWA PLC
For details of YASKAWA PLCs, refer to the following
manuals.
YASKAWA PLC user's Manual

Parameter settings
Make the parameter settings with a peripheral tool.
(1) Settings for CP-218IF
Item
Module Type
CPU Number
Circuit Number
Hot Swapping
Item CNO 03
Local Port 10500
Node IP
192.168.001.018
*1
Address
Node
05016
*1
Port
Connection
TCP
Type
Protocol Extended
Type MEMOBUS
Code BIN
*1 Be sure to set the values above for the address so that the
GOT communicates with the programmable controller
correctly.
For the Host Address setting on the GOT side, refer to the
following.
6.3.2 ■ Ethernet setting
(2) Settings for CP-218IF
Item
IP Address
Transmission
Response Time
parameter
Count of Retry
setting
(Number of Retries)
Connection Number
Local Port
Node IP Address
Connection
Node Port
parameter
Connection Type
setting
Protocol Type
Code
Node Name
6 - 28
6. CONNECTION TO YASKAWA PLC
6.3 Ethernet Connection
Set value
CP-218
01
01
CNO 04 CNO 05
10501 10030
192.168.001.020 192.168.001.073
05017 21001
TCP UDP
Extended Extended
MEMOBUS MEMOBUS
BIN BIN
Set value
IP address for 218TXB
Not required
Not required
1
10500
Local IP address of GOT
Local port No. of GOT
UDP
Extended MEMOBUS
BIN
Any string

Settings by DIP switch
(1) Settings for 218TXB
Set the DIP switch (SW2) as follows.
ON
Setting Item Set value
N/O Mode Selection
*1
Not used
-
Transmission
10/100
Speed
Transmission
F/H
Mode
INIT Initial Startup
*2
Test
TEST
*1 Turn off all the unused switches.
When even one of those switches is on, the PLC may not
normally operate.
*2 When the PLC is started with the TEST switch on, the
module starts the self-diagnosis and may not perform the
communication.
Turn off the switch before the communication is started.
N/O
-
10/100
F/H
-
-
INIT
TEST
OFF
Setting range
ON: Extended mode (13
channels, up to 1024 words)
ON
OFF: Basic mode (10 channels,
up to 512 words)
OFF -
ON :10Mbps
OFF
OFF :100Mbps
ON: Full duplex mode
OFF
OFF: Half duplex mode
ON: Start up by the default IP
address and the engineering port
No.
OFF
OFF: Start up by the IP address
and the engineering port No. set
for CP-717
ON: The module starts the self-
diagnosis when the PLC is
started.
OFF
OFF: The module does not start
the self-diagnosis when the PLC
is started.