Mitsubishi Electric GOT1000 Series Connection Manual page 118

Graphic operation terminal
Hide thumbs Also See for GOT1000 Series:
Table of Contents

Advertisement

(2) Precautions when preparing a cable
(a) Cable length
The length of the RS-485 cable must be within the
maximum distance.
(b) GOT side connector
For the GOT side connector, refer to the following.
1.4.1 GOT connector specifications
(c) FUJI PLC side connector
Use the connector compatible with the FUJI PLC
side module.
For details, refer to the user's FUJI PLC manual.
(3) Connecting terminating resistors
(a) GOT side
When connecting a PLC to the GOT, a terminating
resistor must be connected to the GOT.
• For GT16, GT15, GT12
Set the terminating resistor setting switch of the
GOT main unit to "100 OHM".
• For GT14, GT11
Set the terminating resistor selector to "330 ".
For the procedure to set the terminating resistor,
referFor the procedure to set the terminating
resistor, refer to the following.
1.4.3 Terminating resistors of GOT
(b) FUJI PLC side
When connecting a FUJI PLC to the GOT, a
terminating resistor must be connected.
4.2.7 PLC Side Setting
4 - 16
4. CONNECTION TO FUJI PLC
4.2 Serial Connection

Advertisement

Table of Contents
loading

Table of Contents