Installation & Quick Start Up Guide - InnovaSpa Olexia Owner's Manual

INSTALLATION AND
Follow these instructions for quick and easy start up of your new spa. If you have any questions concerning start up,
contact your dealer or Lumi-O directly for help.
OUTDOOR INSTALLATION
If you are going to install your spa outdoors, select a solid, level surface to place it on. The bottom of your spa is totally protected and
it will not rot. Special preparation, such as concrete pad or wood deck, is not mandatory, although they make very suitable bases. If
installing your spa on a wood deck, ensure that the deck is built to code and that it will withstand the filled weight of the spa. When full,
your spa will weigh approximately 41 kg (90 lbs) per square foot. If the spa is not installed on a wooden deck, you need to install it on a
concrete slab of at least 4 inches (10 cm) (see the picture below). Ensure that you do not install your spa underneath overhead power
lines.
INDOOR INSTALLATION
If you are going to install your spa indoors, you should ensure that your doorway is at least 36 inches (91 cm) wide. The location where
you intend to place your spa should be equipped with adequate ventilation, to remove chemical odors and added humidity, and adequate
drainage to handle splashing and in case of a spa leak. It is not recommended to install your spa above a ground level floor.
INSTALLATION
1. Move your spa to the location where it will be installed. Leave at least 18 inches (46 cm) ofspace all around the spa so you have
access to components, and make sure the cover will open properly.
2. If you plan to operate your spa using a 110V circuit, remove the 12' electrical cord, with attached GFCI, from the equipment
compartment. This electrical cord is already connected to your spa and must be plugged into a dedicated 15A wall outlet. DO NOT
plug the cord into your electrical outlet until you have completed step 4 and your spa is full of water. DO NOT use an extension cord. DO
NOT remove the GFCI from the electrical cord. This will void your spa's electrical approval. If you plan to operate your spa using a 220V
electrical supply, you will be required to install a 220V 40A (minimum) GFCI breaker and to connect your spa to this GFCI breaker and
the electrical panel using a grounded 6 AWG/3 wire if the spa is more than 50' from the wall outlet, or using a grounded 8 AWG/3
wire if the spa is located within 50' from the wall outlet. We recommend using a certified electrician to install your GFCI breaker and
to connect your spa to your house electrical panel. If your spa only runs on a 220V electrical circuit, no conversion id needed for the
spa pack. If your spa is is convertible from 110V to 220V, you will find instructions to convert the spa pack on the inside of the spa
pack cover. Ensure that the 220V breaker is disconnected until you have completed step 4 and your spa is full of water.
QUICK START UP GUIDE
18" (0.5 )
m
clearance
20
4" (10 )
cm concrete slab