Table of Contents
Advertisement
Auto power down
The main unit is automatically turned off if there is no audio
input and when you do not use it for approx. 20 minutes.
Press and hold [HDMI (ARC)] for
more than 4 sec. to select the mode.
Depending on the mode, the indicator will blink as below.
Mode
Indicator
On
Off
≥ The indicator for the selected setting blinks for 5 sec. and
then exits the setting mode.
≥ The setting is maintained until it is changed again.
Bluetooth
standby
®
This function allows you to connect a paired Bluetooth
®
device when the main unit is in standby mode.
Press and hold [OPTICAL] for more
than 4 sec. to select the mode.
Depending on the mode, the indicator will blink as below.
Mode
Indicator
On
Off
≥ The indicator for the selected setting blinks for 5 sec. and
then exits the setting mode.
≥ The setting is maintained until it is changed again.
≥ If the AC mains lead is unplugged, the Bluetooth
standby
®
function may not work. Make the setting again.
Dimmer mode
You can turn off dimmer mode and keep the LED
indicators bright.
Press and hold [SURROUND] for more
than 4 sec. to turn off the mode.
≥ The indicator for the current condition will turn brighter.
≥ The setting is maintained until it is changed again.
≥ Default setting of this function is on.
≥ To turn on dimmer mode, repeat the operation above. After performing
the operation, the indicator for the current condition will be dim.
Volume limitation
If a state of the lowered volume disturbs you every
time the main unit turns on, for example, it is
possible to turn off this function as follows:
Press [SURROUND], [SOUND]*,
[SURROUND]*, [SOUND]* consecutively.
* Within 3 sec.
Depending on the mode, the indicator will blink as
below.
Mode
Indicator
On
Off
≥ To turn on Volume limitation, repeat the operation above.
Remote control code
When other Panasonic devices respond to this
system’s remote control, change the remote
control code on this system and the remote
control.
Preparation
≥ Turn off all other Panasonic products.
≥ Turn on the main unit.
∫ To set the code to code 2
1
Aim the remote control at the main unit’s
remote control signal sensor.
[SOUND]
[
-PAIRING]
2
Press and hold
and
on the remote control for more than
4 sec.
Depending on the mode, the indicator will blink as
below.
Code
Indicator
Code 1
Code 2
≥ To select the code 1, press and hold [SOUND] and
[OPTICAL] for more than 4 sec.
Page 21
Hide quick links:
Advertisement
Table of Contents
