Step 3 Wireless Connections; Active Subwoofer Wireless Connection; Bluetooth ® Connection - Panasonic SC-HTB688 Operating Instructions Manual

Step 3 Wireless connections

Active subwoofer
wireless connection
Preparation
≥ Turn on the main unit.
Check that the wireless link is activated.
WIRELESS LINK indicator
Lights:
The wireless link is activated.
Lights off:
The wireless link is not activated.
Blinks:
The active subwoofer is trying to activate the
wireless link with the main unit.

≥ The wireless link will be activated when the main unit and
the active subwoofer are both turned on.
≥ The I/D SET button is only used when the main unit is not
paired with the active subwoofer. ( 24)
Bluetooth
®
By using the Bluetooth
to the sound from the Bluetooth
from this system wirelessly.
≥ Refer to the operating instructions of the Bluetooth
further instruction on how to connect a Bluetooth
Preparation
≥ Turn on the Bluetooth
place the device near the main unit.
Bluetooth
®
Press [ -PAIRING] to select "
≥ If the " " indicator starts blinking quickly, go to step 3.
18
TQBJ2019
connection
connection, you can listen
®
audio device
®
device for
®
device.
®
feature of the device and
®
pairing
Press and hold [
the "
≥ If the " " indicator blinks slowly, repeat step 2.
Select "SC-HTB688", "SC-HTB498" or
"SC-HTB488" from the Bluetooth
device's Bluetooth
≥ The MAC address (e.g., 6C:5A:B5:B3:1D:0F) may be
displayed before "SC-HTB688", "SC-HTB498" or "SC-
HTB488" is displayed.
≥ If prompted for the passkey on the Bluetooth
"0000" or "1234".
≥ Once the Bluetooth
stops blinking and lights up.

≥ You can register up to 8 devices with this system. If a 9th
device is paired, the device that has not been used for the
longest time will be replaced.
Connecting a paired
Bluetooth
Press [
If the
" " indicator lights, a Bluetooth
≥
connected with this system. Disconnect it. ( below)
Select "SC-HTB688", "SC-HTB498" or
"SC-HTB488" from the Bluetooth
device's Bluetooth
∫ Disconnecting a Bluetooth
Press and hold [
indicator blinks slowly.

≥ When " " is selected as the source, this system will
automatically try and connect to the last connected
Bluetooth device. If the connection attempt fails, try to
®
establish a connection again.
≥ The Bluetooth
®
audio source (e.g. "HDMI (ARC)") is selected.
≥ This system can only be connected to one device at a time.
".
-PAIRING] until
" indicator blinks quickly.
menu.
®
device is connected, the "
®
device
®
-PAIRING] to select "
device is already
®
menu.
®
-PAIRING] until the "
device will be disconnected if a different
®
device, enter
®
" indicator
".
®
device
®
"