Firmware Update Through The Internet - Yamaha RX-V475 Service Manual

RX-V475/HTR-4066/RX-V500D

Firmware Update Through the Internet

Requirement:
Internet connection
Your receiver is connected to the Internet if you can receive Internet radio stations.
(See owner's manual for details)
1 Power off the receiver (Standby mode)
2 Enter the ADVANCED SETUP mode
While pressing the STRAIGHT key, press the
" A D V A N C E D S E T U P " appears on the front panel display.
*
" A D V A N C E D S E T U P " is displayed only for a few seconds.
3 Select "FIRM UPDATE" from the menu
a. Press the PROGRAM key until " U P D A T E . . . . . U S B " is displayed.
b. Then, press STRAIGHT key until " N E T W O R K " is displayed.
4 Start fi rmware update
a. Press INFO key to start the update.
(Update process may take up to 15 minutes)
*
If " U P D A T E S U C C E S S " appears, this means your receiver is already up-to-date. In this case, power off to
exit from Advanced Setup. Your AV receiver is ready for normal use.
N E T W O R K U P D A T E
Caution
DO NOT interrupt power during the update.
In case the power is accidentally cut off resulting in a condition where you can't recover normal operation, refer
to the troubleshooting method (Troubleshooting CASE 2) on the last page.
b. When completed, " U P D A T E S U C C E S S " appears on the display.
c. Turn off the power of the receiver by pressing the
(Power) key
PROGRAM key
136
RX-V475/HTR-4066
(Power) key and keep STRAIGHT key pressed until
A D V A N C E D S E T U P
U P D A T E . . . . . U S B
Firmware update in progress
V E R I F Y I N G . . .
U P D A T E S U C C E S S
INFO key
RX-V500D
U P D A T E . N E T W O R K
(Power) key.
STRAIGHT key
S x - x : x x %