Pioneer DDJ-SX2 Service Manual page 48

1
A Each of the above items can be set in Utility mode or Jog Dial Touch Sensor Sensitivity Adjustment mode.
To enter Utility mode, disconnect the USB cable from the PC then press the STANDBY/ON switch on the rear panel of this unit
to set it to Standby. Then while holding the SHIFT and PLAY/PAUSE buttons on the left deck pressed, press the STANDBY/ON
switch to set it to ON.
To start this unit in Jog Dial Touch Sensor Sensitivity Adjustment mode, connect the PC and this unit, using the supplied USB
cable, then while holding the SHIFT button pressed, press the DECK1 or DECK3 button for the left jog dial or press the
DECK2 or DECK4 button for the right jog dial.
(For details, refer to the operating instructions of the unit.)
Sheet for confirmation of the user setting
B
MIDI controller setting
Auto Compulsion
Crossfader start setting
with SYNC Without SYNC
Light/flash setting
of the SLIP button
Flashing Lit 1 min
C
After touch setting
Enable Disenable
Microphone output
setting to Booth monitor
Output Non output
White illuminations (Left deck)
Pattern 1 Pattern 2 Pattern 3
D
Setting for backspin length
Short Normal Long
-17 -16 -15 -14 -13 -12 -11 -10 -9 -8 -7 -6 -5 -4 -3 -2 -1 0 +1 +2 +3 +4 +5 +6 +7 +8 +9 +10+11+12+13+14+15+16+17
E
F
48
1
2
Channel fader start setting
with SYNC Without SYNC
Disenable
Demo mode setting
5 min 10 min Disenable
Operation setting for
NEEDLE SEARCH pad
Limit Non limit
Illuminations mode setting for jog dial
Pattern 4 Pattern 5 Pattern 1
High-pass filter operation
setting for microphone sound
Enable Disenable
Jog dial touch sensor
sensitivity adjustment
2
3
Disenable
Attenuator level setting
for the Master output
0 dB -3 dB -6 dB
Velocity curve setting
Curve 1 Curve 2
Cut lag setting for crossfader
0 1 to 5 to 51
White illuminations (Right deck)
Pattern 2 Pattern 3
MIDI message operation
setting for crossfader
Enable
DDJ-SX2
3
4
Flashing setting
in Slip mode
Enable Disenable
Curve 3 Curve 4
52
Red illuminations
Pattern 4 Pattern 5 Lit
Disenable
4
Flashing