Pioneer DDJ-SX2 Service Manual page 41

5
• CONTROL and MIX PCB Assemblies
(1) Remove the all knobs.
(2) Remove the Front panel by removing the
33 screws.
(602-HP1010K-182-HA)
Detachment/Reattachment of the front panel
For replacement of the CONTROL A/B PCB Assy or MIX PCB Assy, the front panel must be detached.
The front panel is secured to the Chassis Assy with double-back tape at 4 locations for prevention of lifting. Be fully careful not to deform the
front panel when detaching it.
• About the double-back tape that is used for securing the front panel and the Chassis Assy
When detaching the front panel
The front panel and the Chassis Assy are secured with 4 pieces of double-back tape at the locations shown in the photo below.
Slowly peel off the tape, taking care that you will not deform the front panel.
When reattaching the front panel
1 Neatly remove any residue of double-back tape from the back of the front panel and the Chassis Assy.
2 Stick 4 pieces (5 mm × 40 mm) of NITTO No. 500 double-back tape to the locations shown in the photo below then remove the paper liner.
Note: Even if double-back tape was not used in the initial state, be sure to attach double-back tape when reattaching the front panel.
Double-back tape
Double-back tape
5
6
1
×39
2
×33
Double-back tape
Double-back tape
DDJ-SX2
6
7
Front panel
Double-back tape: NITTO No. 500
(5 mm × 40 mm)
7
8
A
B
C
D
E
F
41
8