Electrolux icon Use And Care Manual page 7

CAUTION
D
o Not loosen or remove these 3 hex
screws.
Level Refrigerator & Ad-
just Doors (if necessary)
Guidelines for final positioning of your
refrigerator:
• All four corners of the cabinet must
rest firmly on the floor.
• The sides should tilt ¼ inch (6 mm)
from front to back (to ensure that
doors close and seal properly).
• Doors should align with each other
and be level.
Most of these conditions can be met by
raising or lowering the adjustable front rollers.
To level the cabinet using the front rollers:
1 Slightly open freezer drawer.
2 Remove the toe grille (following the
illustrations below for the toe grille on
your model).
Figure 1: Remove screws and then
gently pull forward.
Figure 1
DO NOT
Loosen
or
Remove
These 3
Hex
Screws
3 You can raise or lower each door.
4 Ensure both doors are bind-free with
5 After unit is leveled, lower anti-tip leg
6 Install the toe grille by fitting into
Installation
Figure 2: Lift the toe grille and gently
pull forward.
Clip
Shoulder
Screw
Figure 2
Use a 3/8 inch socket wrench to turn
the adjustment screws (1 per side).
To raise: turn adjustment screw
clockwise.
To lower: turn adjustment screw
counterclockwise.
their seals touching the cabinet on all
four sides and that cabinet is stable.
until it contacts the floor.
Door
Raise
Anti-tip
Leg
Lower
place (replacing screws on some
models).
Shoulder
Screws
Toe
Grille
Door
7