HP 5920 series Configuration Manual page 44
Hide thumbs
Also See for 5920 series:
- Command reference manual (607 pages) ,
- Configuration manual (424 pages) ,
- Fc and fcoe configuration manual (257 pages)
Table of Contents
Advertisement
Configuration procedure
This example uses BEB 1 to show the configuration procedure. You can configure other SPBM devices in
the same way you configure BEB 1.
1.
Configure the new B-VLAN (VLAN 20 in this example):
Perform this task on all BEBs and BCBs in the SPBM network.
# Create VLAN 20.
<BEB1> system-view
[BEB1] vlan 20
[BEB1-vlan20] quit
# Map B-VLAN 20 to MSTI 4092, and activate the change.
[BEB1] stp region-configuration
[BEB1-mst-region] instance 4092 vlan 20
[BEB1-mst-region] active region-configuration
[BEB1-mst-region] quit
# Assign the provider network ports to VLAN 20.
[BEB1] interface ten-gigabitethernet 1/0/1
[BEB1-Ten-GigabitEthernet1/0/1] port trunk permit vlan 20
[BEB1-Ten-GigabitEthernet1/0/1] quit
[BEB1] interface ten-gigabitethernet 1/0/3
[BEB1-Ten-GigabitEthernet1/0/3] port trunk permit vlan 20
[BEB1-Ten-GigabitEthernet1/0/3] quit
2.
Map B-VLAN 20 to ECT algorithm 2.
Perform this task on all BEBs and BCBs in the SPBM network.
[BEB1] spbm
[BEB1-spbm] ect 2 b-vlan 20
[BEB1-spbm] quit
3.
Assign B-VLAN 20 to I-SID 1000.
Perform this task on all BEBs in the SPBM network.
[BEB1] vsi web
[BEB1-vsi-web] spb i-sid 1000
[BEB1-vsi-web-1000] b-vlan 20
[BEB1-vsi-web-1000] quit
[BEB1-vsi-web] quit
[BEB1] quit
Verifying the configuration
1.
Verify the configuration and forwarding states during ECT migration:
On BEBs (BEB 1 in this example):
# Verify the ECT migration configuration for I-SID 1000.
<BEB1> display spbm ect-migration i-sid 1000
ECT
00-80-c2-02
00-80-c2-03
The output shows that I-SID 1000 is migrating from ECT algorithm 3 to ECT algorithm 2. During
this period, both B-VLAN 10 and B-VLAN 20 can transmit traffic.
B-VLAN
T
R
20
1
1
10
1
1
40
Advertisement
Table of Contents
