HP ProLiant BL p-Class GbE2 User Manual page 68

5. After the message in step 4 displays, reconfigure your terminal emulation console with
the following parameters.
Parameter
Baud Rate
Data Bits
Parity
Stop Bits
Flow Control
6. Press Enter several times on the keyboard of the PC that is connected to the console port
of the GbE2 Interconnect Switch. When the console port is successfully communicating
with the PC, indicating readiness for image tranfer, you see continuous C's:
CCCCCCCCCCCCCCCCC
7. Make sure that the new Switch Operating System firmware file is available on the
computer. This file can be downloaded from the CD that is shipped with the GbE2
Interconnect Switch or from HP website.
8. Select <Transfer-Send File> from the menu and choose the following options in the send
file window:
file: pGbE2_100.bin (100 represents the version number of Switch
Operating System firmware)
protocol: 1K XMODEM
The send file window displays the progress of the file transfer. It takes about five
minutes for the transfer to complete.
NOTE: Although slower, XModem also works if you choose not to use 1K MODEM.
9. After completing the transfer, a message displays prompting how many bytes transferred,
followed by another message prompting image extraction. Do not power cycle the switch
during this process.
HP ProLiant BL p-Class GbE2 Interconnect Switch User Guide
HP CONFIDENTIAL Codename: Strawberry Part Number: 331399-001 Last Saved On: 7/17/03 2:30 PM
Value
115200
8
None
1
None
CAUTION: Do not power off the GbE2 Interconnect Switch until you see the message:
"Change your baud rate to 9600 bps and the power cycle switch," otherwise, the GbE2
Interconnect Switch will be inoperable.
Performing a Serial Download
E-5