Subscribe to Our Youtube Channel
Related Manuals for Remington MB4850AU
Summary of Contents for Remington MB4850AU
- Page 1 BARBER’S BEST BEARD TRIMMER USE & CARE MANUAL PLEASE READ PRIOR TO USE To register your product go to www.remington-products.com.au 5 YEAR WARRANTY MB4850AU...
-
Page 2: Important Safety Instructions
Unplug and switch off this appliance before cleaning it. • Use this appliance only for its intended use as described in this manual. • Do not use attachments not recommended by Remington. • Never drop or insert any object into any opening of this appliance. •... - Page 3 This appliance should be supplied with approved safety isolating adaptors SW-120060AU (for Australia) with the output capacity of 12Vdc; 600mA (adaptor output). Remington strongly recommends that an approved Safety Switch (Residual current device) be installed to protect all bathroom power outlets. Ask an electrical contractor for advice.
-
Page 4: Key Parts
MB4850AU BARBER’S BEST BEARD TRIMMER USE AND CARE MANUAL Thank you for purchasing your Remington® Barber’s Best Beard Trimmer. Inside this manual you will find instructions on using and caring for your new trimmer. KEY PARTS On/Off Switch Also Includes Adjustable Zoom Wheel •... -
Page 5: Cleaning And Maintenance
ABOUT YOUR BEARD TRIMMER MB4850AU SPECIFICATIONS Power System Cord/Cordless (Rechargeable) Full Charge Time 4 Hours Runtime 120 Minutes Indicators LED Charging/Low/Full Voltage Type Worldwide 100-240V (adaptor voltage type) CHARGING • Before using your trimmer for the first time, charge it for 4 hours. Note during this charge ignore the electronic indicators as they are in “start-up cycle”. - Page 6 • After each use, it is recommended to clean hair from blades using the cleaning brush or by rinsing the blades under running water. When rinsing the blades it is necessary to lubricate them once dry. With the unit turned off apply 3 drops of oil to the moving blade facing up, one drop on each end and one in the middle, then switch the unit on for a few seconds to distribute the oil, then turn the unit off and wipe off excess oil.
- Page 7 NOTE: Use the beard trimmer without the adjustable comb for trimming hair close to the skin. This will trim hair to 1mm, holding the blades perpendicular to the skin will trim hair to 0.4mm. ATTACHING AND REMOVING THE BLADES • To remove, press the release button and pull upwards and away from the trimmer.
-
Page 8: Battery Removal
BATTERY REMOVAL • Remove the blade cartridge from the trimmer. • Remove the 4 screws from the back side of the trimmer body. • Pry apart the two halves of the trimmer body to expose the internals. • With the top half of the trimmer body removed and the internals facing upward, pull the end of the charge port upward to release the battery enclosure. -
Page 9: Warranty Against Defects
Spectrum Brands Australia Pty Ltd and Spectrum Brands New Zealand Limited WARRANTY AGAINST DEFECTS In this warranty: Australian Consumer Law means the Australian consumer law set out in Schedule 2 to the Competition and Consumer Act 2010; CGA means the New Zealand Consumer Guarantees Act 1993; Goods means the product or equipment which was accompanied by this warranty and purchased in Australia or New Zealand, as the case may be;... - Page 10 New Zealand 0800 736 776 (toll free) AUTHORISED REPAIR CENTRES Visit www.remington-products.com.au for Authorised repair centre details. ® Registered Trade Mark of Spectrum Brands Inc. or one of its subsidiaries Made in China to the specifications of Spectrum Brands, Inc.
Need help?
Do you have a question about the MB4850AU and is the answer not in the manual?
Questions and answers