Table of Contents
Advertisement
shown on each display.
Note: The indicated ID for the dock is unique and will vary from dock to dock.
Run the Intel® Wireless Dock Manager software
To connect the dock to your laptop wirelessly, you need to use Intel Wireless Dock
Manager software. The software should be pre-installed on any WiGig equipped
laptop. The software must be intially run on each laptop you want to connect the dock
to.
1. If you do not have Intel Wireless Dock Manager software, download, install, and
run the latest version from Intel, or contact your laptop manufacturer.
Note: Ensure the version you are running is 2.6.1.102 or higher. If you have the
software installed but are unsure of which version you are running click the About
icon (question mark) within the software. You can also click the Settings icon (gear) to
be given an option to check for updates at Intel.com.
2. Run the Intel Wireless Dock Manager software. If you receive a notification that says:
"Your PC is not currently connected to a dock. To connect to a dock, click here and
select the dock you want", click the word "here". Otherwise, proceed to step three.
3. Click on your dock ID to connect the dock to your laptop.
4. Push the Connect button on the dock to continue the installation and to wirelessly
connect the dock to your laptop. Once connected the software will display a
message that says "Successfully Connected to Dock_****. "
Notes
• If you receive a pop-up notification that says "Connection is weak" move the dock
closer to the laptop.
• For dual-display configurations, see the "Configure a display device" section.
Install the drivers and connect your peripherals
The required drivers will install automatically when the dock is powered and wirelessly
connected to your host laptop.
• Connect your peripherals to the dock (for example, USB devices, RJ 45 network).
• Do not connect anything to the USB-C port while in WiGig mode.
Instruction manual
6
Advertisement
Table of Contents
Need help?
Do you have a question about the DKWG30DPHPD and is the answer not in the manual?
Questions and answers