Advertisement
ENGLISH
Injuries caused by prolonged use
u
of a tool. When using any tool for
prolonged periods ensure you take
regular breaks.
Impairment of hearing.
u
Health hazards caused by breathing
u
dust developed when using your
tool (example:- working with wood,
especially oak, beech and MDF.)
Labels on Appliance
The following pictograms are shown on
the tool along with the date code:
Warning! Read the manual prior
to operation.
Wear safety glasses or goggles
when operating this appliance.
Wear suitable ear protection
when operating this appliance.
Do not expose the tool to rain or
high humidity or leave outdoors
while it is raining.
Switch off: remove plug from
mains before cleaning or
maintenance.
Beware of flying objects.
Keep bystanders away.
Directive 2000/14/EC
guaranteed sound power.
Features
1. Variable speed control
2. Cable restraint
3. Collection bag
4. Upper blow tube
5. Lower blow tube
6. Upper vacuum tube
7. Middle vacuum tube
8
(Original instructions)
8. Lower vacuum tube
9. Vac release button
10. Bag release button
11. Powerhead
12. Second handle
Assembly
Warning! Before assembly, make sure that the
appliance is switched off and unplugged.
Warning! Always wear protective gloves when
working with your blow vac.
Vacuum tube assembly (fig. A)
The vacuum tubes must be assembled together before use.
Warning! Do not operate the appliance with the vacuum tubes
separated.
To ease assembly, apply a soapy water solution to the
u
joint area.
Align the notches (13) and the triangles (14) on the upper
u
(6) and middle (7) vacuum tubes.
Push the upper vacuum tube (6) firmly onto the middle
u
vacuum tube (7) until the triangles click into place.
Align the notches (13) and the triangles (14) on the middle
u
(7) and lower (8) vacuum tubes.
Push the middle vacuum tube (7) firmly onto the lower
u
vacuum tube (8) until the triangles click into place.
Warning! Do not separate the tubes once assembled.
Attaching the second handle (fig. B)
Press in and hold both of the buttons (15) on the side of
u
the handle mount.
Slide the second handle (12) in place over the buttons
u
(15).
Note: Ensure that the orange button is is on the same side as
the large hole in the handle.
Warning! Ensure that the teeth on the button are correctly
aligned in slots in the handle and that the handle is secure.
Adjusting the position of the second handle (fig. C)
The second handle (12) can be adjusted to provide optimum
balance and comfort.
Press in the button (15) on the left side of the handle.
u
Rotate the second handle (12) into the required position.
u
Release the button (15).
u
Warning! Ensure that the teeth on the button are correctly
aligned in slots in the handle and that the handle is secure.
Advertisement
