Initialize Mode - Pioneer PDP-4271HD Service Manual

1

8.2.4 INITIALIZE MODE

Operation item
A
No.
8.2.4.1 SYNC DET(+)
8.2.4.2 SG MODE
8.2.4.3 SG PATTERN
8.2.4.4 SIDE MASK LEVEL(+)
8.2.4.5 FINAL SETUP(+)
8.2.4.6 HMG/HG SERVICE MODE
8.2.4.7 CVT AUTO
B
8.2.4.8 HDMI INTR POSITION(+)
Note : When there is an altered history due to an open TRAP SW, if the "DISPLAY" key is held for at least
5 seconds on the above menu, the altered history will be cleared and the unit will be back to normal.
8.2.4.1 SYNC DET(+)
Exclusively used for technical analsyis (details omitted).
8.2.4.2
SG MODE
SG MODE (SG's route selection)/SG PATTERN (signal pattern selection) are used as pair.
C
In SG MODE, select the SG route and then select the SG pattern to be sent by the selected
route. In SG MODE, make sure to select the route first.
D
No.
1 SG OFF
E
2 DIG MVDEC YCBCR
3 ANA MVDEC YCBCR
4 ANA MVDEC Y
5 ANA AD YCBCR
6 ANA AD RGB
F
144
1
2
Display
Exclusively used for technical analsyis.
Paired SG_MODE with SG_PATTERN.
Select SG Route.
Paired SG_MODE with SG_PATTERN.
Select SG Pattern.
Configure the color of the side mask.
Initialize flash memorys on virgin product status
Enter HMG/HG SERVICE MODE
Exclusively used for technical analsyis.
Exclusively used for technical analsyis.
Display
SG Mode is OFF.
MAIN VDEC: YCbCr (Digital output mode)
MAIN VDEC: YCbCr (Analog output mode)
MAIN VDEC: Y (Analog output mode: SG VDEC return setting)
AD: YCbCr
AD: RGB
PDP-4271HD
2
3
Content RS232C
Content
3
4
-
-
-
BSL
GSL
RSL
FST
-
-
-
4