Installing The Panels; Automatic Drive Detection Mode - JVC MC-8200LU Instructions Manual

Drive Units

7-5. Installing the panels

CAUTION
s Check the installation screws and cables before installing the panel. Insufficient connections may cause malfunctions.
1.
Attach rear and side panels.
• Screw the panels on, following the procedure in "7-1 Removing the panel" on page E22 in the reverse order.
2.
Close the door
( a See "5. Door Opening/Closing" on page E18.)

7-6. Automatic drive detection mode

Note:
After installing, adding, exchanging or removing drives, be sure to execute the auto drive detection mode to prevent any malfunction.
1.
While holding the "8" key on the control panel, turn on
the MC-8200LU/8600LU.
2.
When the LCD display shows "DRIVE DETECTION
COMPLETED", turn off the power of the MC-8200LU/
8600LU.
3.
Turn the MC-8200LU/8600LU on again.
Downloaded From DvDPlayer-Manual.com JVC Manuals
D E T E C T I N G D R I V E S
. . . . . P L E A S E
D R I V E D E T E C T I O N
C O M P L E E D
W A I T