Before You Call - Electrolux EXP12HN1WI User Manual

32 www.electrolux.com
Wash the filter using liquid dishwashing
detergent and warm water. Rinse filter
thoroughly. Gently shake excess water
from the filter. Be sure filter is thoroughly
dry before replacing.
Or, instead of washing you may vacuum
the filter clean.
7.2 Cabinet Cleaning
Be sure to unplug the air conditioner
to prevent shock or fire hazard. The
cabinet and front may be dusted with
an oil-free cloth or washed with a cloth
dampened in a solution of warm water
and mild liquid dishwashing detergent.
Rinse thoroughly and wipe dry.

8. BEFORE YOU CALL

Air conditioner will not operate.
Wall plug disconnected. Push plug
firmly into wall outlet.
Plug Current Device Tripped. Press the
RESET button.
House fuse blown or circuit breaker
tripped. Replace fuse with time delay
type or reset circuit breaker.
Control is OFF. Turn Control ON and set
to desired setting.
P1 appears in the display window.
Drain water as described in Drainage
Section.
Shut off in Heat mode. When the air
outlet exceeds 70 °C (158 °F), the
automatic heat protection engages.
Romove any blockages and let
appliance cool down.
Room Temperature lower than the set
temperature (Cool Mode). Reset the
temperature.
Room Temperature higher than the set
temperature (Heat Mode). Reset the
temperature.
Air from unit does not feel cold
enough.
Room temperature below 16 °C (60 °F).
Cooling may not occur until room
temperature rises above 16 °C (60 °F).
Never use harsh cleaners, wax or polish
on the cabinet front.
Be sure to wring excess water from
the cloth before wiping around the
controls. Excess water in or around the
controls may cause damage to the air
conditioner.
7.3 Winter Storage
If you plan to store the appliance during
the winter, cover it with plastic or return
it to its carton.
For the model which with accessory
of storage cover, use it directly for the
appliance storage.
Reset to a lower temperature.
Compressor shut-off by changing
modes. Wait approximately 3 minutes
and listen for compressor to restart
when set in the COOL mode.
Air conditioner cooling, but room is
too warm - NO ice forming on cooling
coil behind decorative front.
Outdoor temperature below 16 °C
(60 °F). To defrost the coil, set FAN
ONLY mode.
Air filter may be dirty. Clean filter. Refer
to Care and Cleaning section. To
defrost, set to FAN ONLY mode.
Temperature is set too low for night-
time cooling. To defrost the coil,
set to FAN ONLY mode. Then, set
temperature to a higher setting.
Exhaust duct not connected or
blocked. See EXHAUSTING HOT AIR
Section.
Air conditioner cooling, but room is
too warm - ice forming on cooling coil
behind decorative front
Dirty air filter - air restricted. Clean
air filter. Refer to Care and Cleaning
section.
Temperature is set too high. Set
temperature to a lower setting.