Specifications - Makita T221D Instruction Manual

ENGLISH
1-1. Battery cartridge
1-2. Set plate
2-1. Nut
3-1. Tool end (A)
3-2. Material
3-3. Less than 2 mm (5/64")

SPECIFICATIONS

Applicable staples length
Staple magazine capacity
Dimentions (L x W x H)
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
Intended use
The tool is intended for pressing staples into
construction materials such as timbers.
EC-DECLARATION OF CONFORMITY
Model; T221D
We declare under our sole responsibility that this
product is in compliance with the following standards of
standardized documents;
EN60745, EN55014
Directives, 2004/108/EC, 98/37/EC.
000230
Tomoyasu Kato
Responsible Manufacturer:
Makita Corporation
3-11-8, Sumiyoshi-cho, Anjo, Aichi, JAPAN
Authorized Representative in Europe:
Makita International Europe Ltd.
Michigan Drive, Tongwell, Milton Keynes, Bucks MK15
8JD, ENGLAND
ADDITIONAL SAFETY RULES
FOR TOOL
1. Always wear safety goggles or safety glasses
with side shield, and a full face shield when
needed.
2. Do not point the ejection port at anyone in the
vicinity (especially his face). Keep hands and
feet away from the ejection port area.
Explanation of general view
4-1. Switch trigger
4-2. Safety lever
5-1. Sight window
6-1. Press
6-2. Slide backward
6-3. Plate spring
Model
Staple width
Net weight
Rated voltage
in accordance with Council
CE2007
Director
10 mm, 13 mm, 16 mm, 19 mm, 22 mm
ENE054-1
3. Always remove the battery cartridge before
loading the staples, adjustment, inspection,
maintenance or after operation is over.
4. Make sure no one is nearby before operation.
ENH102-7
Never attempt to drive staples from both the
inside and outside of wall at the same time.
Staples may rip through and/or fly off,
presenting a grave danger.
5. Watch your footing and maintain your balance
with the tool. Make sure there is no one below
when working in high locations.
6. Check walls, ceilings, floors, roofing and the
like carefully to avoid possible electrical
shock, gas leakage, explosions, etc. caused
by stapling into live wires, conduits or gas
pipes.
7. Use only staples specified in this manual. The
use
malfunction of the tool.
8. Do not tamper with the tool or attempt to use it
for other than driving staples.
9. Do not operate the tool without staples. It
shortens the service life of the tool.
10. Stop driving operations immediately if you
notice something wrong or out of the ordinary
ENB069-1
with the tool.
11. Never staple into any materials which may
allow the staple to puncture and fly through as
a projectile.
12. Never actuate the switch trigger and safety
lever at the same time until you are prepared
to staple workpieces. Allow the workpiece to
depress the safety lever. Never defeat its
purpose by securing the safety lever back or
by depressing it by hand.
13. Never tamper with the safety lever. Check the
3
7-1. Staples
8-1. Plate spring
8-2. Press
8-3. Push
T221D
10 mm
100 pcs
199 mm x 58 mm x 193 mm
1.7 kg
D.C. 9.6V
of any other staples may cause