Cisco ONS 15600 Series Reference Manual page 262

13.7.2 Variable Trap Bindings
Table 13-5 15600 SNMPv2 Trap Variable Bindings (continued)
Group Associated Trap Name(s)
B dsx3LineStatusChange
(from RFC 2496, not
applicable to
ONS 15600 but
applicable to other
platforms)
C coldStart (from RFC
1907)
warmStart (from RFC
1907)
newRoot (from RFC)
topologyChange (from
RFC)
entConfigChange (from
RFC 2737)
authenticationFailure
(from RFC 1907)
Cisco ONS 15600 Reference Manual, R7.0
13-8
(Variable
Binding
Number) SNMPv2 Variable Bindings Description
(1) dsx3LineStatus
(2) dsx3LineStatusLastChange The value of MIB II's sysUpTime object at the
(3) cerentGenericNodeTime
(4) cerentGenericAlarmState
(5) snmpTrapAddress
(1) cerentGenericNodeTime
(2) cerentGenericAlarmState
(3) snmpTrapAddress
— —
— —
— —
This variable indicates the line status of the
interface. It contains loopback state information
and failure state information.
time this DS3/E3 entered its current line status
state. If the current state was entered prior to the
last reinitialization of the proxy-agent, then the
value is zero.
The time that an event occurred.
The alarm severity and service-affecting status.
Severities are Minor, Major, and Critical.
Service-affecting statuses are Service-Affecting
and Non-Service Affecting.
The address of the SNMP trap.
The time that an event occurred.
The alarm severity and service-affecting status.
Severities are Minor (MN), Major (MJ), and
Critical (CR). Service-affecting statuses are
Service-Affecting (SA) and Non-Service
Affecting (NSA).
The address of the SNMP trap (not supported for
ONS 15600).
(Not supported for ONS 15600)
—
—
Chapter 13 SNMP