Greasing - Sanyo Hv-Dx1E Service Manual

MAINTENANCE/INSPECTION PROCEDURE

5-2) Greasing

(1) Greasing guidelines
Apply grease, with a cleaning patch. Do not use excess
grease. It may come into contact with the tape transport
or drive system. Wipe any excess and clean with clean
ing patch wetted in Isopropyl Alcohol.
NOTE:Greasing Points
1) Loading Path Inside & Top side
2) Base Tension Boss inside Hole
3) Arm Assembly F/L "U" Groove
4) Arm Take-up Rubbing Section
5) L/D Motor Gear Wheel Part
2
1
6
Chassis (Top)
Gear Part
Gear Sector
Base Loading
Bracket Side (L)
6) Shaft
7) Arm Assembly F/L of Buming
Inside Hole
8) Reel S, T Shaft (G381:Yellow)
9) Brake T Groove
4
3
5
Gear Cam
Gear Drive
Guide Rail
Bracket Assembly Door
(2) Periodic greasing
Grease specified locations every 5,000 hours.
1) Loading Path Inside & Top side
2) Shaft
3) Gear Rack F/L Moving Section
4) Shaft
3
4
6
Chassis (Bottom)
Guide Rack F/L
4-21
5) Lever Tension Groove
6) Clutch Assembly D33 Shaft
7) Brake "S" Rubbing Section
2
7
5
Gear Rack F/L
1
8