Configuring Qos Settings; Configuring Ftp Settings - HIKVISION iVMS-4200 User Manual

A reboot is required for the settings to take effect.
•
To lower the risk of information leakage, you are suggested to enable SNMP v3
•
instead of SNMP v1 or v2.

7.6 Configuring QoS Settings

Purpose:
QoS (Quality of Service) can help solve the network delay and network congestion by
configuring the priority of data sending.
Steps:
1. Enter the QoS Settings interface: Configuration > Advance Configuration >
Network > QoS
2. Configure the QoS settings, including Video/Audio DSCP, Event/Alarm DSCP
and Management DSCP.
The valid value range of the DSCP is 0 to 63. The bigger the DSCP value is, the
higher the priority is.
Note:
DSCP refers to the Differentiated Service Code Point; and the DSCP value
is used in the IP header to indicate the priority of the data.
3. Click Save to save the settings.
Note: A reboot is required for the settings to take effect.

7.7 Configuring FTP Settings

Purpose:
Network Camera User Manual
Figure 7-9 QoS Settings
55