Periodic Maintenance Procedures
Measure the supercharger impeller axial play [A] using
the pliers [B].
Supercharger Impeller Axial Play
If the supercharger impeller axial play exceeds the service
limit, replace the supercharger impeller housing assy.
Chassis Parts Lubrication
Before lubricating each part, clean off any rusty spots with
rust remover and wipe off any grease, oil, dirt, or grime.
Lubricate the points listed below with indicated lubricant.
Whenever the vehicle has been operated under
wet or rainy conditions, or especially after using a
high-pressure water spray, perform the general lubri-
Pivots: Lubricate with Grease.
Rear Master Cylinder Push Rod Joint Pin
Points: Lubricate with Grease.
Throttle Inner Cable Upper and Lower Ends [A]
Cables: Lubricate with Rust Inhibitor.
Lubricate the cables by seeping the oil between the cable
The cable may be lubricated by using a commercially
available pressure cable lubricator with an aerosol cable
0.5 mm (0.02 in.)
PERIODIC MAINTENANCE 2-73