Meter, Gauge, Indicator Unit
Check 3-1: CAN Communication Line Resistance In-
Connect a tester [A] to the terminal  and  in the meter
CAN Communication Line Resistance (at Meter
If the tester reading is not specified, replace the meter
Check 3-2: Meter Unit Power Supply Check
Using the auxiliary leads, the 12 V battery [A] to the meter
unit connector as follows.
Connect the battery positive (+) terminal to the terminal
  .
Connect the battery negative (-) terminal to the terminal
Check the following items.
The tachometer needle [A] momentarily points their last
readings and back to the minimum position.
The engine speed indicator light goes on synchronously
with the movement of the tachometer needle.
The indicator lights (LED) [B] and all LCD segments [C]
go on for a few seconds.
If the meter unit does not work, replace the meter unit.
Check 3-3: Blue High Beam Indicator Light (LED) In-
Connect the leads in the same circuit as Check 3-2.
Connect the terminal  or  to the battery (–) termi-
Check that the blue high beam indicator light (LED) [A]
If the indicator light does not go on, replace the meter unit.
123 125 Ω
ELECTRICAL SYSTEM 16-65