16-34 ELECTRICAL SYSTEM
The ignition system produces extremely high volt-
age. Do not touch the spark plug, stick coil or stick
coil lead while the engine is running, or you could
receive a severe electrical shock.
Do not disconnect the battery cables or any other
electrical connections when the ignition switch is
on, or while the engine is running. This is to prevent
Do not install the battery backwards. The negative
side is grounded. This is to prevent damage to the
Crankshaft Sensor Removal
Never drop the sensor, especially on a hard surface.
Such a shock to the sensor can damage it.
Clutch Cover (see Clutch Cover Removal in the Clutch
Right Fuel Tank Cover (see Fuel Tank Cover Removal
in the Frame chapter)
Right Inner Cover (see Inner Cover Removal in the
Remove the crankshaft sensor lead connector [A] from
the bracket to outside, and disconnect it.
Crankshaft Sensor Bolts [A]
Crankshaft Sensor [B]
Crankshaft Sensor Installation
Torque - Crankshaft Sensor Bolts: 6.0 N·m (0.61 kgf·m, 53
Using a high flash-point solvent, clean off any oil or dirt
that may be on the liquid gasket coating area. Dry them
with a clean cloth.
Apply liquid gasket [A] to whole periphery of the crank-
shaft sensor lead grommet groove.
Sealant - Liquid Gasket, TB1211F: 92104-0004