Clutch Master Cylinder
Align the punch mark [A] on the handlebar with the mating
surface [B] of the master cylinder clamp.
Tighten the upper clamp bolt first, and then the lower
clamp bolt. There will be a gap at the lower part of the
clamp after tightening.
Torque - Clutch Master Cylinder Clamp Bolts: 9.0 N·m (0.92
kgf·m, 80 in·lb)
Replace the washers that are on each side of the hose
fitting with new ones.
Install the clutch hose (see Cable, Wire, and Hose Rout-
ing section in the Appendix chapter).
Torque - Clutch Hose Banjo Bolt: 25 N·m (2.5 kgf·m, 18
Replenish the clutch fluid into the reservoir and bleed the
clutch line (see Bleeding the Clutch Line).
Check that the clutch line has proper fluid pressure and
no fluid leakage.
Connect the starter lockout switch lead connector and in-
stall the clamps (see Cable, Wire, and Hose Routing Sec-
tion in the Appendix chapter).
Install the upper fairing (see Upper Fairing Installation in
the Frame chapter).
Clutch Master Cylinder Disassembly/Assembly
The clutch master cylinder cannot disassemble. If a in-
ternal components replacement are required, replace the
clutch master cylinder as an assembly.
Clutch Master Cylinder Inspection
Remove the clutch master cylinder [A] (see Clutch Master
Check the clutch master cylinder for leakage, and replace
the clutch master cylinder assembly if necessary.
Check the clutch master cylinder for damage, deformation
or crack and replace the clutch master cylinder assembly
Do not try to disassemble the clutch master cylinder.