5-30 ENGINE TOP END
Valve Guide Installation
Apply engine oil to the valve guide outer surface before
Heat the area around the valve guide hole to about 120
150°C (248 302°F).
Do not heat the cylinder head with a torch. This Will
warp the cylinder head. Soak the cylinder head and
heat the oil.
Using the valve guide driver [A] and spacer [B], press and
insert the valve guide in until the attachment surface [C]
touches the head surface.
13.3 13.5 mm (0.524 0.531 in.) [D]
Special Tools - Valve Guide Driver: 57001-1564
Spacer 9.6: 57001-1830
Ream the valve guide with valve guide reamer [A], even
if the old guide is reused.
Special Tool - Valve Guide Reamer, 4.5: 57001-1333
Valve-to-Guide Clearance Measurement (Wobble
If a small bore gauge is not available, inspect the valve
guide wear by measuring the valve to valve guide clearance
with the wobble method as indicated below.
Insert a new valve [A] into the guide [B] and set a dial
gauge against the stem perpendicular to it as close as
possible to the cylinder head mating surface.
Move the stem back and forth [C] to measure valve/valve
Repeat the measurement in a direction at a right angle to
If the reading exceeds the service limit, replace the guide.