3-82 FUEL SYSTEM (DFI)
Tighten the fuel tank bolts [A] [D] following specified
[A → B → C → D → A → B]
Install the removed parts (see appropriate chapters).
Fuel Tank and Cap Inspection
Open the tank cap.
Visually inspect the gasket [A] on the tank cap for any
Replace the tank cap if gasket is damaged.
Check to see if the water drain pipe [B] and fuel breather
pipe [C] in the tank are not clogged. Check the tank cap
If they are clogged, remove the tank and drain it, and then
blow the breather free with compressed air.
Do not apply compressed air to the air vent holes
[D] in the tank cap. This could cause damage and
clogging of the labyrinth in the cap.
Fuel Tank Cleaning
Gasoline and low flash-point solvents can be
flammable and/or explosive and cause severe
burns. Clean the tank in a well-ventilated area, and
take care that there are no sparks or flame any-
where near the working area. Do not use gasoline
or low flash-point solvents to clean the tank.
Fuel Tank (see Fuel Tank Removal)
Fuel Pump (see Fuel Pump Removal)
Pour some high flash-point solvent into the fuel tank and
shake the tank to remove dirt and fuel deposits.
Draw the solvent out of the fuel tank.
Dry the tank with compressed air.
Fuel Pump (see Fuel Pump Installation)
Fuel Tank (see Fuel Tank Installation)