3-48 FUEL SYSTEM (DFI)
Open the fuel tank cap [A] to lower the pressure in the
Remove the primary fuel hose from the fuel pump (see
Fuel Tank Removal).
Be sure to place a piece of cloth around the fuel outlet
pipe of the fuel pump.
Connect the prepared fuel hose [A] to the fuel outlet pipe.
Secure the fuel hose with a clamp.
Insert the fuel hose into the measuring cylinder [B].
Wipe off spilled out fuel immediately.
Be sure to hold the measuring cylinder vertical.
Close the fuel tank cap.
Turn the engine start/stop switch to run position.
Turn the ignition switch on.
The fuel pump should operate for 3 seconds, and then
Do not drive the fuel pump 3 seconds or more with-
out the fuel in the fuel tank. If the fuel pump is driven
without the fuel, it may be damaged.
Measure the discharge for 3 seconds.
Repeat this operation several times.
Amount of Fuel Flow
83 mL (2.8 US oz.) or more for 3 seconds
Turn the ignition switch off.
If the fuel flow is much less than the specified, replace the
fuel pump (see Fuel Pump Removal/Installation).
Install the fuel tank (see Fuel Tank Installation).
Start the engine and check for fuel leakage.