Cisco ASA5506W-X Configuration Manual page 9

http 0.0.0.0 0.0.0.0 inside
asa#
Aironet WAP Configuration (without the example SSID config)
asa# session wlan console
ap>enable
Password: Cisco
ap#configure terminal
Enter configuration commands, one per line.
ap#show configuration | include default-gateway
ip default-gateway 10.1.0.1
ap#show configuration | include ip route
ip route 0.0.0.0 0.0.0.0 10.1.0.1
ap#show configuration | i interface BVI|ip address 10
interface BVI1 ip address
10.1.0.254 255.255.255.0
FirePOWER Module Configuration (with inside switch)
asa# session sfr console
Opening console session with module sfr.
Connected to module sfr. Escape character sequence is 'CTRL-^X'.
> show network
===============[ System Information ]===============
Hostname
Domains
DNS Servers
Management port
IPv4 Default route
Gateway
======================[ eth0 ]======================
State
Channels
Mode
MDI/MDIX
MTU
MAC Address
----------------------[ IPv4 ]---------------------Configuration
Address
Netmask
Broadcast
----------------------[ IPv6 ]----------------------
Configuration
===============[ Proxy Information ]================
State
Authentication
>
FirePOWER Module Configuration (without inside switch)
asa# session sfr console
Opening console session with module sfr.
Connected to module sfr. Escape character sequence is 'CTRL-^X'.
> show network
===============[ System Information ]===============
: Cisco_SFR
: example.net
: 10.0.0.250
: 8305
: 10.0.0.1
: Enabled
: Management & Events
:
: Auto/MDIX
: 1500
: B0:AA:77:7C:84:10
: 10.0.0.254
: 255.255.255.0
: 10.0.0.255
: Disabled
: Disabled
: Disabled
End with CNTL/Z.
: Manual