Pioneer KRP-500P Service Manual page 75

5
Command
P
PGG
S08 Green gamma setting: Fixed at 2.3
S09 Green gamma setting: Fixed at 2.4
S10-31 Green gamma setting: Customized
PGH *** Panel white balance adjustment-Green high-light
PGL *** Panel white balance adjustment-Green low-light
PGX *** Panel Gx measurement value
PGY *** Panel GY measurement value
PGR S00 Red gamma setting: Straight
S01 Red gamma setting: Fixed at 1.6
S02 Red gamma setting: Fixed at 1.7
S03 Red gamma setting: Fixed at 1.8
S04 Red gamma setting: Fixed at 1.9
S05 Red gamma setting: Fixed at 2.0
S06 Red gamma setting: Fixed at 2.1
S07 Red gamma setting: Fixed at 2.2
S08 Red gamma setting: Fixed at 2.3
S09 Red gamma setting: Fixed at 2.4
S10-31 Red gamma setting: Customized
PKD S00 Peak Brightness Detection: OFF
S01 Peak Brightness Detection: ON
PKL S00 No brightness limitation: 100%
S01 Brightness limitation1: 87%
S02 Brightness limitation2: 73%
S03 Brightness limitation3: 60%
S04 Brightness limitation4: 52%
S05 Brightness limitation5: 40%
S06 Brightness limitation6: 27%
S07 Brightness limitation7: 13%
PMT S00 To cancel panel muting
S01 Panel muting
POF To turn the unit OFF
PON To turn the unit ON
PPT S00 Panel Protection function: OFF
S01 Panel Protection function: ON
PRH *** Panel white balance adjustment-Red high-light
PRL *** Panel white balance adjustment-Red low-light
PRX *** Panel Rx measurement value
PRY *** Panel Ry measurement value
Q
QAJ To acquire various adjustment values
QAL To acquire the NG (SD) history managed by the Panel Main microcomputer
QPB To acquire various data managed by the Panel Main microcomputer
QPD To acquire the history of power-down places
QPM To acquire pulse-meter data
QPW To acquire white balance adjustment data of the panel
QPF To acquire characteristics/function settings data of the panel
QS1 To acquire panel information, such as software versions
QS2 To acquire panel status data, such as acquired temperatures
of the panel in cases of operation changes
QS3 To acquire panel information other than the above
QS5 To acquire panel information (Individual functions)
QSB To acquire versions of various microcomputers of the panel main unit
QSP To acquire subversions of various microcomputers of the panel
QSD To acquire shutdown data
QSI To acquire signal-related data
5
6
Command
Receiving UCOM
Function
MOD
KRP-500P
6
7
Effective only
Last
Memory during FAY
PM
MOD
MOD
MOD
MOD
Muting cannot be performed while the built-in mask
signal output is being displayed.
PM
PM
MOD
MOD
MOD
MOD
7
8
A
Remarks
B
C
D
E
F
75
8