List Of Rs-232C Commands - Pioneer KRP-500P Service Manual

5

5.8 LIST OF RS-232C COMMANDS

Note: While the display is in System Operation mode (SYSS01) with the Media Receiver (MR,) among the received commands via the
RS-232C connector on the display, only the SYS commands are valid.
To enable other RS-232C commands, set the display to Standalone Operation mode (SYSS00).
RS-232C command list
Command
A
ABL *** To adjust the upper limit of power
ALM S00 To enable SD operation of the display main unit
S01 To disable SD operation of the display main unit
AP0 S** Addresses L1 and L2 setting
AP1 S** Addresses L3 and L4 setting
AP2 S** Addresses U1 and U2 setting
AP3 S** Addresses U3 and U4 setting
APN *** Average number of pulses for 1V
AMP S00 To set audio muting to OFF
S01 To set audio muting to ON
B
BCP To copy EEPROM data for backup
S01 To set the baud rate for the RS-232C connector on the panel to 1200 bps
BRA
S02 To set the baud rate for the RS-232C connector on the panel to 2400 bps
S03 To set the baud rate for the RS-232C connector on the panel to 4800 bps
S04 To set the baud rate for the RS-232C connector on the panel to 9600 bps
S00 Afterimage/Burn-In Reduction mode: OFF
BSM
S01 Afterimage/Burn-In Reduction mode: ON
BZS S00 Bezel Setup: EP
S01 Bezel Setup: R1 (Black)
S02 Bezel Setup: R2 (White)
S03 Bezel Setup: R3 (Beige)
C
CAL To clear the NG (SD) history managed by the Panel Main microcomputer
CBU To set Backup setting to "No backup"
CHM To clear hour-meter data
CMT To clear stored maximum-temperature data
CPC To clear the power-on count
CPD To clear the power-down history
CPM To clear pulse-meter data
CSD To clear the shutdown history of the DIGITAL Assy of the display unit
CSF S00 Color sensor function: OFF
S01 Color sensor function: ON
S01 Color Space mode 1: Pioneer original standard
CSM
S02 Color Space mode 2: In compliance with the EBU standard
CSB *** Color sensor blue coefficient
CSG *** Color sensor green coefficient
CSR *** Color sensor red coefficient
CTP S00 Color temperature setting: OFF
S01 Color temperature setting: LOW
S02 Color temperature setting: MID LOW
S03 Color temperature setting: MID
S04 Color temperature setting: MID HIGH
S05 Color temperature setting: HIGH
D
DIZ S00 Dither/L dither: OFF, noise: OFF
S01 Dither/L dither: ON, noise: ON
S02 Dither/L dither: OFF, noise: ON
S03 Dither/L dither: ON, noise: OFF
S00 Panel drive-power: OFF
DRV
S01 Panel drive-power: ON
5
6
Command
Receiving UCOM
Function
MOD
KRP-500P
6
7
Last Effective only
during FAY
Memory
PM
MOD
PM
PM
MOD For enabling changed setting, it is necessary to
turn the unit off then back on again.
MOD
MOD
MOD
MOD
MOD
PM Corresponding to reception via the RS-232C
connector on the display
PM
PM
PM
PM For use by engineers
PM
PM
PM
PM
MOD
MOD
MOD
MOD
MOD
MOD
MOD
MOD
MOD
MOD
7
8
A
Remarks
B
C
D
E
F
71
8