Modes; Setting The Clock On The Charging Dock; Auto Clean - Black & Decker BDH5000 Instruction Manual

2. Choose the mode and press the
corresponding button; spot (1), clean
(2), or max (3); on either the top of
the vacuum or the remote (24). The
vacuum will begin cleaning.
3. To stop the vacuum, press any button
on the vacuum or remote.
4. To turn the vacuum off completely,
press the side of the power switch
marked "OFF".

MODES

Spot mode - Press the spot button (1)
to select this mode. The vacuum will
clean in a spiral pattern for approximately
2-5 minutes. If the battery runs low, the
vacuum will automatically search for the
charging dock (21). This mode is ideal for
cleaning small areas, about 11 sqft (1m²).
Clean mode - Press the clean button
(2) to select this mode. The vacuum will
clean for 30 minutes depending on the
objects around it. If the battery runs low,
the vacuum will automatically search
for the charging dock (21). This mode
is ideal for small rooms with less than
215 sqft (20m ).
2
Max mode - Press the max button (3)
to select this mode. The vacuum will
operate until the battery is low. When
the battery runs low, the vacuum will
automatically search for the charging
dock (21). This mode is ideal for
large rooms.
Driving with remote - This mode allows
you to control where the vacuum goes.
1. Press the side of the power switch (11)
marked "ON".
2. Press the cursor buttons (30) on
the remote to make the vacuum go
forward, backward, left, and right
(Figure E).
NOTE: Repeatedly press the left, right,
and backward buttons to make the
vacuum move in that respective direction.
Once the button is released, the vacuum
will resume moving forward.
NOTE: The cursor buttons will not drive
the vacuum if any of the preset modes are
activated or if the power switch is "OFF".
E
30
SETTING THE CLOCK ON THE
CHARGING DOCK (FIGURE A, F)
1. Press the clock button (32) once. The
hour digits (36) on the LED screen (22)
will blink. Press the + or - buttons (34
and 35) to set the current hour.
2. Press the clock button a second time.
The minute digits (37) will blink. Press the
+ or - buttons to set the current minute.
3. Press the clock button a third time.
The day of the week (38) will blink at
the top of the LED screen. Press the +
or - buttons to set the current day of
the week.
4. Press the clock button a fourth time to
exit clock set up.
F
36
SET
31 32
AUTO CLEAN (FIGURES A, F, G)
Once the battery is fully charged, the
vacuum will automatically leave the
charging dock (21) and clean under
max mode.
1. Press the Charge+Start button (31)
to quickly set the auto-go function.
The "GO" icon (39) will appear in the
bottom-right corner of the LED screen
(22), indicating the auto clean function
is active.
2. Press the Charge+Start button a
second time to deactivate auto clean.
5
38 37
Su Mo Tu We Th Fr Sa
CLK
09:24
1
GO
2
33 34 35