Table of Contents
Advertisement
Terminal Setup
Starting a Telnet Session
At the Twin Client main menu on the terminal, press any key to establish the connection.
Until the terminal has been authorized, the following screen is displayed.
RECOVERABLE ERROR
Terminal not
Authorized for
Twin Client
Keypress to Continue
It is not necessary to authorize the terminal at this time, so press any key to continue. The
terminal will establish a connection with the host system and start emulation. If the
terminal fails to connect to the host, refer to the following tables.
Failure Cause
Incorrect Host IP address
Incorrect netmask value
Error Indication
NOT Associated
No AirLoad
Manager Found.
Manager not Active
Unable to open
connection
Timeout waiting for
data
Download aborted
Manager inactive
After a Telnet session has been successfully established, the terminal will remain in
session for a maximum of 30 minutes at a time until it has been authorized. Once
authorized, there is no software restriction on the session time. The instructions for
authorizing the terminal are presented in Authorizing PowerNet.
2-12
Corrective Action
Correct the Host List address on the terminal. Refer to
Terminal Setup Using Twin Client Menus.
Access the Edit Functions menu. Correct the netmask
value. Refer to Terminal Setup Using Twin Client Menus.
Possible Cause
Invalid NETID
AirLoad Manager not
active, or not installed
on the LAN segment.
Previously identified
AirLoad Manager is no
longer found.
IP stack on terminal
failed to load.
Transient
communications
failure
Socket closed during
download
PC not operating
Corrective Action
Run current radio setup program and
set NETID to match the access point.
See Terminal Setup Using Twin Client
Menus.
Ensure that the PC with Twin Client
Manager is on the same segment and
that the PC is operating. If the PC is
not on the same segment, enter the
address of the PC in response to the
terminal prompt.
Same as above
Reload Program Files and reboot.
Reboot terminal. If problem persists,
check the RFSYNC.log in the
PowerNetTN directory.
Ensure that PC is operating. Reboot
terminal and retry.
Restart the Airload PC server.
Supported Equipment Manual
•
May, 2006
Advertisement
Table of Contents
