Table of Contents
Advertisement
Toolbar
Under the menu bar, the tool bar provides shortcuts to major features. The toolbar can be
turned on or off by changing the Toolbar parameter found on the
shortcuts available from the toolbar are as follows.
The PowerNet Twin Client Manager is now successfully installed and ready for use.
Quick Start provides detailed instructions for quickly configuring the terminal and
starting a Telnet session.
Quick Start
Quick Start describes how to prepare the Twin Client Manager and the Fujitsu terminal
for a Telnet session with the host. Following an initial setup procedure, the terminal
software and configuration is managed automatically, over the wireless network.
Configuring the Manager
The first step is to configure the Twin Client Manager to meet site-specific requirements,
and then prepare it for the automatic management of the terminal software and IP
addresses. This simple procedure will require only a few minutes to complete.
Setting the Emulation
Click on
menu, as shown below.
Supported Equipment Manual
Create a new terminal configuration.
Open an existing terminal configuration.
Save the current terminal configuration.
Download the configuration to terminal.
Download software to terminal.
Configure terminals automatically over the wireless network.
View PowerNet Twin Client Manager version.
,
,
Start
Programs
PowerNet
•
May, 2006
, and
Twin Client Manager
Terminal Setup
menu. The
View
. Select the
Settings
2-5
Advertisement
Table of Contents
