Installing the DC-in Adapter Port
1
Place the DC-in adapter port into the slot on the palm-rest assembly.
2
Route the power-adapter port cable through its routing guides on the palm-rest assembly.
3
Replace the M2x3 screw that secures the power-adapter port to the palm-rest assembly.
4
Connect the power-adapter port cable to the system board.
5
Install the:
a
battery
b base cover
6
Follow the procedures in After Working Inside Your Computer.
Display Assembly
Removing the Display Assembly
1
Follow the procedures in
2
Remove the:
a
Base cover
b
battery
3
Perform the following steps:
a
Remove the screw securing the metal bracket [1].
b Lift the metal bracket off the computer [2].
c
Disconnect the LVDS cable from the system board [3].
22
Removing and installing components
Before Working Inside Your
Computer.