Lights; Vacation And Moving Care - Haier HRB10N2 Installation And User Manual

LIGHT
Depending on your model, the light located behind
the Temperature control, may use either an LED or an
incandescent bulb. To order a replacement light bulb for your
model, call 1-877-337-3639 or visit us at www.haieramerica.
com/support.
To Replace a Light Bulb:
NOTE: You may need to remove the top shelf to access the
light bulb.
1. Unplug refrigerator or disconnect power.
2. Remove the screw fastening the light shield, and then
remove the light shield.
3. Remove the burned-out bulb and replace it with an
appliance bulb of the same size, shape and wattage.
IMPORTANT:
•
DO NOT replace with an incandescent bulb greater
than 10 Watts.
•
The refrigerator compartment is considered to be a
wet/damp environment, and some LED replacement
bulbs are not recommended for wet/damp
environments. Before installation, read and follow all
instructions on the LED packaging.
4. Replace the light shield.
5. Plug in refrigerator or reconnect power.

VACATION AND MOVING CARE

VACATION
If You Choose to Leave the Refrigerator On While You're
Away:
1. Use up any perishables and freeze other items.
If You Choose to Turn Off the Refrigerator Before You
Leave:
1. Remove all food from the refrigerator and freezer.
2. Unplug refrigerator or disconnect power.
3. Clean refrigerator, wipe it, and dry well.
4. Tape rubber or wood blocks to the tops of both doors to
prop them open far enough for air to get in. This stops
odor and mold from building up.
10
MOVING
WARNING
Fire or Explosion Hazard
Do not puncture refrigerant tubing.
Follow handling instructions carefully.
Flammable refrigerant used.
Failure to do so can result in death, explosion or re.
IMPORTANT: Handle with care when moving refrigerator to
avoid either damaging the refrigerant tubing or increasing
the risk of a leak.
WARNING
Excessive Weight Hazard
Use two or more people to move and install refrigerator.
Failure to do so can result in back or other injury.
When you are moving your refrigerator to a new home, follow
these instructions to prepare it for the move.
IMPORTANT:
•
If possible, move the refrigerator in an upright position.
If the refrigerator must be moved horizontally, it must be
placed only on its right-hand side (as you are facing the
front of the refrigerator). After standing the refrigerator
upright, wait at least 12 hours to allow the system to
settle before plugging in the refrigerator.
1. Remove all food from the refrigerator and pack all frozen
food in dry ice.
2. Unplug refrigerator.
3. Empty any water in the drain tray.
4. Make sure that the defrost water drain tube at the back of
the refrigerator is attached to the drain tray on the top of
the compressor, to avoid defrost water spilling onto the
floor.
5. Take out all removable parts, wrap them well, and tape
them together so they will not shift and rattle during the
move.
6. Wash and rinse the interior, and then dry thoroughly.
7. Raise the leveling legs so they don't scrape the floor. See
"Leveling."
8. Tape the doors closed and tape the power cord to the
back of the refrigerator.
9. When you get to your new home, put everything back and
refer to the "Installation Instructions" section.