Pixit For Goose Publish Model; Pixit For Goose Subscribe Model; Pixit For Goose Performance - GE UR Series Manual

PIXIT CONFORMANCE STATEMENT
ID Ed
Rp10 1,2
Rp12 2
Table 3-124: PIXIT for GOOSE publish model
ID Ed
Gp1 1,2
Gp3 1,2
3
Gp4 1,2
Gp5 1,2
Gp7 1,2
Table 3-125: PIXIT for GOOSE subscribe model
ID Ed
Gs1 1,2
Gs2 1,2
Gs3 1,2
Gs4 1,2
Gs5 1,2
Gs8 1,2
Gs9 1,2
Table 3-126: PIXIT for GOOSE performance
ID Ed
Gf1 1,2
Gf2 1,2
3-138
Description
What is the scan cycle for binary events?
Is this fixed, configurable?
After restart of the server is the value of ConfRev restored from
the original configuration or retained prior to restart?
Description
Can the test (Ed1) / simulation (Ed2) flag in the published
GOOSE be set?
Published FCD supported common data classes are
What is the slow retransmission time?
Is it fixed or configurable?
What is the fastest retransmission time?
Is it fixed or configurable?
What is the initial GOOSE sqNum after restart?
Description
What elements of a subscribed GOOSE header are
checked to decide the message is valid and the
allData values are accepted? If yes, describe the
conditions.
Notes:
• The VLAN tag may be removed by a Ethernet switch
and shall not be checked
• The simulation flag shall always be checked (Ed2)
• The ndsCom shall always be checked (Ed2)
When is a subscribed GOOSE marked as lost?
(TAL = time allowed to live value from the last received
GOOSE message)
What is the behavior when one or more subscribed
GOOSE messages isn't received or syntactically
incorrect (missing GOOSE)?
What is the behavior when a subscribed GOOSE
message is out-of-order?
What is the behavior when a subscribed GOOSE
message is duplicated?
Subscribed FCD supported common data classes are... None.
Are subscribed GOOSE with test=T (Ed1) / simulation=T
(Ed2) accepted in test/simulation mode?
Description
Performance class
GOOSE ping-pong processing method Scan cycle based
CHAPTER 3: IEC 61850 COMMUNICATION
Value / Clarification
1/8 cycle (2.0 ms @60 Hz, 2.5
ms @50 Hz)
Fixed
Retained prior to restart
Value / Clarification
Y
The "S" bit in the GOOSE
"Reserved 1" word is not set.
All instantiated FCDs
Arrays are not supported
1000 to 60000 ms
Configured by SCL
2 to 100 ms
Configured by SCL
sqNum = 1
Value / Clarification
Y destination MAC address
Configurable APPID
Y gocbRef
Y timeAllowedtoLive
Configurable datSet
Configurable goID
N t
Y stNum
N sqNum
Y simulation / test
Configurable confRev
Y ndsCom
Y numDatSetEntries
a) Message does not arrive prior to TAL
When a subscribed GOOSE is marked
as lost, a Self Test Alarm target is
generated, and all internal data that is
derived from GOOSE data is assigned
to default values
Sequence number is ignored. State
number is checked for proper order.
Sequence number is ignored
Arrays are not supported.
Y
Value / Clarification
P1
UR SERIES – COMMUNICATIONS GUIDE