Table of Contents
Advertisement
Others
Troubleshooting
∫ It is not a malfunction in following cases
The lens, the viewfinder or
LCD monitor fog up.
A clicking sound is heard
when the unit is shaken.
Object seems to be warped. ≥ Object seems to be warped slightly when the object moves
Problem
This unit cannot be turned
on.
This unit does not stay on
long enough.
Battery runs down quickly.
This unit cannot be
operated though it is
turned on.
This unit does not operate
normally.
"ERROR OCCURRED.
PLEASE TURN UNIT OFF,
THEN TURN ON AGAIN."
is displayed.
≥ This is due to condensation. This is not a malfunction. Please
refer to page 10.
≥ This is the sound of the lens moving and is not a defect.
This sound will no longer be heard when the unit is turned on
and switch to Recording Mode.
across the image very fast, but this is because the unit is using
MOS for the image sensor. This is not a malfunction.
Power
≥ Charge the battery again to ensure it is sufficiently charged.
(l
25)
≥ In cold places, the battery using time becomes shorter.
≥ The battery has a limited life. If the operating time is still too
short even after the battery is fully charged, the battery has
worn out and needs to be replaced.
≥ Remove the battery or AC adaptor, wait about 1 minute and
then reconnect the battery or AC adaptor. Then about
1 minute later, turn on the unit again. (Conducting the above
operation while the SD card is being accessed may damage
the data on the media.)
≥ If normal operation is still not restored, detach the power
connected, and consult the dealer who you purchased this
unit from.
≥ The unit has automatically detected an error. Restart the unit
by turning off and on.
≥ The unit will be turned off in about 1 minute if the unit is not
turned off and on.
≥ Repair is needed if it is repeatedly displayed even if it is
restarted. Detach the power connected, and consult the
dealer who you purchased this unit from. Do not attempt to
repair the unit by yourself.
- 149 -
Check points
Advertisement
Table of Contents
