3 Get started
Use of controls or adjustments or
performance of procedures other than herein
may result in hazardous radiation exposure or
other unsafe operation.
Always follow the instructions in this chapter in
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
rear of the apparatus. Write the numbers here:
Model No. __________________________
Serial No. ___________________________
Mount the set under your
Test TV reception quality
Test the TV reception before mounting the set
under the kitchen cabinet.
If the TV reception is poor, connect the main
unit with a ﬁ x TV cable or buy an active
antenna (PHILIPS SDV 2740, SDV 6122, SDV
Connect the supplied antenna to
Place the main unit as close to open area
or window as possible.
Adjust the place of the main unit until you
get optimal signal reception.
Ask a friend or a professional personnel to
safely mount the product under your kitchen
a. Find a mounting location near a wall outlet.
b. Use the mounting template to test the
design and thickness of your kitchen cabinet.
c. Decide whether you want to connect the
set with other audio/video equipment.
Mounting the set
For full details on how to use the Mounting
Kit, please refer to the printed instructions in
the Quick Start Guide and Template.
Recommended depth of cabinet
at the rear to allow for connections
Never plug in the AC power cord to the
power outlet before installation is completed.
Do not use a converter or extension cord.
Install the set as far as possible from sources of
interference, such as a refrigerator, microwave
oven, ﬂ uorescent lamp, etc.
There should be at least 2.5" distance
between the unit and the wall.
Ask a friend to help you mount the unit as it is quite heavy.
Cut the template to fit inside the cabinet.
Align the template border marked "FRONT"
along the front edge of your cabinet.
Use adhesive tape to fix the template.
Drill 1/4 inch holes (size X.X mm diameter, X
inch), as marked X on the template.
Remove the template when you finish drilling.
– Use a nail to start each drill hole.
– Hold your drill firmly at 90o with the cabinet bottom and drill holes at
– Clear wood shavings.
Using the spacers
On the spacers, there are 4 pairs of notch length
options. Depending on the thickness of you cabi-
net bottom (with/ without an overhang), these
L••H (4 heights)
notch lengths correspond to the 4 notch height in
the space holders, and allow you to adjust to the
best height to help you mount the unit.
Measure the height of the cabinet bottom
T urn the spacer counterclockwise to determine
which of the 4 heights is most suitable: High • •
Inser t the spacers accordingly.
fasten the 4 screws down into the
spacer holder holes to mount your set. If the
overhang is more than 1 1/4 inch, use longer
screws (not included).
T o prevent damage to your set, do not use an electric drill
to secure screws when mounting!
– Hold the unit horizontally when installing it, since the CD tray may
open if the unit is shaken.
– Use the cable manager to manage excess power cord length.