Samsung RF28HMEDBSR Service Manual: When Refrigerator Room Lamp Does Not Light Up

French door refrigerator.
Hide thumbs
TROUBLESHOOTING

4-2-11. When refrigerator ROOM Lamp does not light up

When controlling the regrigerator light with Regulator(12V) : LED LAMP
Applying to the F/R Room compartment (Option)
* If the Vegetable Lamp does not work properly, check the R compartment LED Lamp because it is connected with
the R compartment LED Lamp in parallel. Refer to the circuit diagram to repair.
Door & MICOM State
MICOM(#28)
Door
Right and Left
Close
Open
MICOM State
FF
Door
#28
Close
0V(Low)
Open
5V(High)
IC76(R)/IC77(F) State
IC
IC76(R) / IC77(F) / IC78(MID)
0V(Low)
5V(High)
11~12V(High)
1) Measuring output voltage
- Measuring the voltage of PCB typical Ground J23 JUMMPER and IC76
voltage( CN78-"3"(Red)/R LED), IC77 voltage (CN78-"1"(Brown)/F LED)
R LED Lamp ON
R LED Lamp OF
0V(Low)
5V(High)
FZ(MID)
#29(#40)
0V(Low)
5V(High)
0V(Low)
PCB connector(CN78) output properly?
Start
Does the
No
DOOR S/W sense properly?
(Open/Close)
Yes
Is the output
No
voltage of IC01 MICOM #28
normal?
Yes
Is the output
No
voltage of IC76
normal?
Yes
Is the MAIN
No
PCB connector(CN78) inserted
properly?
Yes
Does the MAIN
No
(11~12V)
Yes
No
Is the LED LAMP
connected properly?
Yes
No
Is the LED LAMP no mal?
Yes
Normal
Checking method of Door switch voltage.
- Measuring voltage of CN76-"12")(Purple)
typical Ground J23 JUMMPER
Close
Open
96
Check/Replace REED S/W,
Magnet ASS`Y
Replace/Repair the PCB
Replace/Rep air the PCB.
Repair IC76
Check the wire
Re-insert the connector
Check the connector terminal
Replace PCB
Check the
connector terminal
Replace LED LAMP
PCB Typical Ground J23
JUMMPER
PCB

   Also See for Samsung RF28HMEDBSR

Comments to this Manuals

Symbols: 0
Latest comments: