3
Close the battery compartment.
Note
•
If you are not going to use the remote control for a
long time, remove the batteries.
•
Do not use old and new or different types of batteries
in combination.
•
Batteries contain chemical substances, so they should
be disposed of properly.
Set clock
1
In standby mode, press and hold PROG/
CLOCK SET on the remote control for
3 seconds.
» The 12 or 24 hour format is displayed.
2
Press
/
to select the 12 or 24 hour
format.
3
Press PROG/CLOCK SET to confirm.
» The hour digits are displayed and begin
to blink.
8
EN
4
Press
/
to select hour and press
PROG/CLOCK SET to confirm.
» The minute digits are displayed and
begin to blink.
5
Press
/
to select minute and press
PROG/CLOCK SET to confirm.
Tip
•
In ECO mode or when the unit is switched on, you can
PROG/CLOCK SET
press
Turn on
•
Press .
» The unit switches to the last selected
source.
» The signal strength indicators flash for
several seconds until the unit boots up.
Switch to standby mode
•
Press
again to switch the unit to standby
mode.
» The clock (if set) is displayed on the
panel.
Switch to ECO mode:
•
Press and hold
» The display panel is dimmed.
Note
•
In single mode, the unit switches to ECO mode
automatically after 15 minutes of inactivity.
•
In group mode, the unit does not go to ECO mode
automatically.
To switch between standby
mode and ECO mode:
•
Press and hold
to view the set clock.
for more than 3 seconds.
for more than 3 seconds.