General - Compaq P1100 Service Manual

The operating instructions mentioned here are partial abstracts
from the Operating Instruction Manual. The page numbers of
the Operating Instruction Manual remain as in the manual.
Setting Up the Monitor
To set up the monitor, ensure that the power is turned off to the
monitor, computer system, and other attached devices, then follow
these steps:
1. Place the monitor in a convenient, well-ventilated location
near your computer.
2. Connect the monitor signal cable 3 to one of the two 15-pin
connectors 4 on the rear panel of the computer and tighten
the screws.
Be sure the signal cable aligns with the 15-pin connector.
Do not force the cable onto the connector or you may
damage the signal cable.
1
2
3. Connect one end of the monitor power cord 1 to the
connector on the back of the monitor and the other end 2 to
an electrical outlet that is easily accessible and close to the
monitor.
SECTION 1

GENERAL

4
3
English 1-3
WARNING: To reduce the risk of electric shock or damage
!
to your equipment:
Do not disable the po wer cord grounding plug. The
grounding plug is an important safety feature.
Plug the power cord into a grounded (earthed)
electrical outlet that is easily accessible at all times.
Disconnect po wer from the monitor by unplug ging
the power cord from the electrical outlet.
Do not place an ything on power cords or cables.
Arrange them so that no one may accidentally step on
or trip over them. Do not pull on a cord or cable.
When unplugging from the electrical outlet, grasp the
cord by the plug.
1-4 English