Steam Cleaning - AEG KS8454801 User Manual

54 www.aeg.com
To clean the appliance, remove the shelf
supports.
1. Pull carefully the supports up and out
of the front catch.
1
2. Pull the front end of the shelf support
away from the side wall.
3. Pull the supports out of the rear
catch.
Install the shelf supports in the opposite
sequence.

13.4 Steam Cleaning

Remove as much dirt as possible
manually.
Remove the accessories and the shelf
support to clean the side walls.
The steam cleaning functions support
the steam cavity cleaning of the
appliance.
For a better performance
you should start the cleaning
function when the appliance
is cool.
The specified time is related
to the duration of the
function and does not
include the time required for
cleaning of the cavity by the
user.
When the steam cleaning function is
active, the lamp is off.
1. Fill the water drawer to the maximum
level.
2. Choose the steam cleaning function
in the menu: Cleaning.
Steam Cleaning - the duration of the
function is around 30 minutes.
a) Activate the function.
b) An acoustic signal sounds when
the programme is completed.
3
2
c) Touch a sensor field to
deactivate the signal.
Steam Cleaning Plus - the duration
of the function is around 75 minutes.
a) Spray a suitable detergent
uniformly in the oven cavity on
both enamel and steel parts.
Before you start the cleaning
procedure, make sure that the
appliance is cold.
b) Activate the function.
After around 50 minutes an
acoustic signal sounds when the
first part of the programme is
completed.
c) Press .
This is not the end of
the cleaning
procedure. Follow
the message in the
display to complete
the cleaning.
d) Wipe the internal surface of the
appliance with a non-abrasive
surface care sponge. You can use
warm water or oven detergents
to clean the cavity.
e) Press .
The final part of the procedure
starts. The duration of this stage
is around 25 minutes.
3. Wipe the internal surface of the
appliance with a non-abrasive surface
care sponge. You can use warm
water to clean the cavity.
4. Remove the remaining water from
the water drawer.
After cleaning keep the appliance door
open for approximately 1 hour. Wait until
the appliance is dry. To speed up the
drying you can heat up the appliance
with hot air at temperature 150 °C for
approximately 15 minutes. You can get
maximum effects of the cleaning function
if you manually clean the appliance
immediately after the function ends.
13.5 Cleaning Reminder
This function reminds you that the
cleaning is necessary and that you should
perform the function: Steam Cleaning
Plus.