Table of Contents
Advertisement
To remove the battery
Main Power Battery (Lithium ion Battery)
(Refer to page
25
for the detail.)
While pressing the battery release button,
remove the battery.
Back-up Battery (Lithium Battery)
≥ For the removal of the battery for disposal at
the end of its service life, please consult
your dealer.
AEEE Yönetmeliğine Uygundur.
AEEE Complies with Directive of Turkey.
Note regarding the Power Management
function specified under COMMISSION
REGULATION (EC) No 1275/2008
implementing Directive 2009/125/EC of the
European Parliament and of the Council.
This device is designed and manufactured for
use at a broadcasting station and/or in a similar
environment.
This device is not equipped with a Power
Management function or the Power
Management function is set to OFF as it will
prevent the device from fulfilling its intended
purpose for the reasons below.
1.
If the device is a Studio Camera, a Weather
Camera, a Mixer or other processor:
A Power Management function may
cause the device to suddenly stop
during recording or while On Air.
2.
If the device is a Studio Monitor:
A Power Management function may
cause video for the confirmation of
whether a signal is normal, or whether
the signal has been lost, to be un-
viewable.
3.
If the device is a Camera Recorder:
A professional camera recorder must be
able to start quickly at any time, but a
Power Management function will cause
an increase in the time taken to resume
from Stand-by mode.
∫ Cautions for use
About this unit
The unit and the SD card become warm
during use. This is not a malfunction.
Keep this unit as far away as possible from
electromagnetic equipment (such as
microwave ovens, TVs, video games etc.).
≥ If you use this unit on top of or near a TV, the
pictures and/or sound on this unit may be
disrupted by electromagnetic wave radiation.
≥ Do not use this unit near cell phones because
doing so may result in noise adversely
affecting the pictures and/or sound.
≥ Recorded data may be damaged, or pictures
may be distorted, by strong magnetic fields
created by speakers or large motors.
≥ Electromagnetic wave radiation generated by
microprocessors may adversely affect this
unit, disturbing the pictures and/or sound.
≥ If this unit is adversely affected by
electromagnetic equipment and stops
functioning properly, turn this unit off and
remove the battery or disconnect AC adaptor.
Then reinsert the battery or reconnect AC
adaptor and turn this unit on.
Do not use this unit near radio transmitters
or high-voltage lines.
≥ If you record near radio transmitters or
high-voltage lines, the recorded pictures and/
or sound may be adversely affected.
About connecting to a PC
≥ A USB 3.0 cable is not supplied with this unit.
Use a commercially-available double-
shielded USB 3.0 cable with a ferrite core.
If possible, we recommend using a cable with
a length of 1.5 m or less.
- 5 -
Advertisement
Table of Contents
