Preparation; Setting Up Application Software - Brother GT-3 Series Instruction Manual

2

Preparation

2-1. Setting up application software

To begin with, install the PDIP's application software [GT-3 PDIP] onto your PC.
At this stage, do not connect the printer to your PC yet.
<TIPS>

You must log into your PC with administrator privileges.

For any PC onto which the GT-3 printer driver has already been installed, its uninstallation will begin when you perform the
procedures mentioned below.
Then, please reinstall the printer driver by performing the procedures mentioned below.
(1) Activate the PC.
(2) Complete all of the current sessions.
(3) Double-click on the [setup.exe] to execute installer.
<TIPS>

For Macintosh, double-click on the [BrotherGT-3_ver***.pkg] execute installer.
(4) Then, the installation procedures will begin. Follow the on-screen instructions to complete the installation.
(5) When the dialog box shown below appears, click the [Install].
(6) After the installation is completed, reactivate the PC.
(7) From [All Programs] in the Start menu, select the [Brother GT-3 Tools] > [GT-3 PDIP].
<TIPS>

For Macintosh, select [Finder] > [Applications] > [GT-3 PDIP.app].
(8) Select your language.
<TIPS>

The language selection window appears only at the initial startup. If you exit the application without selecting your desired
language, the language selection window will appear again at the next startup stage.

The display language at the initial startup is English.
2-1