Notice For The Blue/White Lead; This Product; Power Cord; Speaker Leads - Pioneer AVH-X390BS Owner's Manual

Connection

Notice for the blue/white lead

 When the ignition switch is turned on (ACC ON), a control
signal is output through the blue/white lead. Connect to an
external power amp's system remote control terminal, the
auto-antenna relay control terminal, or the antenna booster
power control terminal (max. 300 mA 12 V DC). The control
signal is output through the blue/white lead, even if the
audio source is switched off.

This product

1
3
2
4
c b a
1 Pioneer navigation system
Please contact your dealer to inquire about the connectable
navigation unit.
2 RGB cable(supplied with Navigation system)
3 Microphone 3 m (9 ft. 10-1/8 in.)
4 This product
5 Wired remote input
Hard-wired remote control adapter can be connected (sold
separately).
6 SiriusXM Connect Vehicle Tuner
Please refer to the instruction manual for SiriusXM Connect
Vehicle Tuner (sold separately).
7 Antenna jack
8 Power supply
9 Fuse (10 A)
a Front output (STD)/High range output (NW)
b Rear output (STD)/Middle range output (NW)
c SubWoofer output (STD)/Low range output (NW)

Power cord

1
2
a
5 6
1 To power supply
2 Power cord
9 8 7
3 Yellow
To terminal supplied with power regardless of ignition switch
position.
4 Red
To electric terminal controlled by ignition switch (12 V DC)
ON/OFF.
5 Orange/white
To lighting switch terminal.
6 Black (ground)
To vehicle (metal) body.
7 Violet/white
Of the two lead wires connected to the back lamp, connect
the one in which the voltage changes when the gear shift
is in the REVERSE (R) position. This connection enables
the unit to sense whether the car is moving forwards or
backwards.
8 Yellow/black
If you use an equipment with Mute function, wire this lead
to the Audio Mute lead on that equipment. If not, keep the
Audio Mute lead free of any connections.
3
4
5
6
7
8
9
c
b b
d
9 Blue/white
Connect to system control terminal of the power amp (max.
300 mA 12 V DC).
a Light green
Used to detect the ON/OFF status of the parking brake. This
lead must be connected to the power supply side of the
parking brake switch.
b Power supply side
c Parking brake switch
d Ground side

Speaker leads

1
2
L
3
5
7 9
F/H
8 a
6
d
R/M
c e
Perform these connections when using a subwoofer without the
optional amplifier.
R
4
51